|
|
|
|
|
|
||
|
|
||
|
|
Trouble Shooting Suspension Problems.
Adjustment locations: Forks
Rebound adjustment (if applicable) is located near the top of the fork. Compression adjustment (if applicable) is located near the bottom of the fork. Spring preload adjustment (if applicable) is generally hex style and located at the top of the fork.
Lack of Rebound
Symptoms:
? Forks are plush, but increasing speed causes loss of control and traction
? The motorcycle wallows and tends to run wide exiting the turn causing fading traction and loss of control.
? When taking a corner a speed, you experience front-end chatter, loss of traction and control.
? Aggressive input at speed lessons control and chassis attitude suffers.
? Front end fails to recover after aggressive input over bumpy surfaces.
Solution: Insufficient rebound. Increase rebound "gradually" until control and traction are optimized and chatter is gone.
Too Much Rebound
Symptoms:
? Front end feels locked up resulting in harsh ride.
? Suspension tucks in and fails to return, giving a harsh ride. Typically after the first bump, the bike will skip over subsequent bumps and want to tuck the front.
? With acceleration, the front end will tank slap or shake violently due to lack of front wheel tire contact.
Solution: Too much rebound. Decrease rebound "gradually" until control and traction are optimized.
Lack of Compression
Symptoms:
? Front-end dives severely, sometimes bottoming out over heavy bumps or during aggressive breaking.
? Front feels soft or vague similar to lack of rebound.
? When bottoming, a clunk is heard. This is due to reaching the bottom of fork travel.
Solution: Insufficient compression. Increase "gradually" until control and traction are optimized.
Too Much Compression
Symptom:
? Front end rides high through the corners, causing the bike to steer wide. It should maintain the pre-determined sag, which will allow the steering geometry to remain constant.
Solution: Decrease compression "gradually" until bike neither bottoms nor rides high.
Symptom:
? Front end chatters or shakes entering turns. This is due to incorrect oil height and/or too much low speed compression damping.
Solution: First, verify that oil height is correct. If correct, then decrease compression "gradually" until chattering and shaking ceases.
Symptom:
? Bumps and ripples are felt directly in the triple clamps and through the chassis. This causes the front wheel to bounce over bumps.
Solution: Decrease compression "gradually" until control is regained.
Symptom:
? Ride is generally hard, and gets even harder when braking or entering turns.
Solution: Decrease compression "gradually" until control is regained.
Adjustment Locations: Rear Shock
Rebound adjustment (if applicable) is located at the bottom of the shock. Compression adjustment (if applicable) is located on the reservoir. Spring prelude is located at the top of the shock.
Shock: Lack of Rebound
Symptoms:
? The ride will feel soft or vague and as speed increases, the rear end will want to wallow and/or weave over bumpy surfaces and traction suffers.
? Loss of traction will cause rear end to pogo or chatter due to shock returning too fast on exiting a corner.
Solution: Insufficient rebound - Increase rebound until wallowing and weaving disappears and control and traction are optimized.
Shock: Too Much Rebound
Symptoms:
? Ride is harsh, suspension control is limited and traction is lost.
? Rear end will pack in, forcing the bike wide in corners, due to rear squat. It will slow steering because front end is riding high.
? When rear end packs in, tires generally will overheat and will skip over bumps.
? When chopping throttle, rear end will tend to skip or hop on entries.
Solution: Too much rebound. Decrease rebound "gradually" until harsh ride is gone and traction is regained. Decrease rebound to keep rear end from packing.
Shock: Lack of Compression
Symptoms:
? The bike will not turn in entering a turn.
? With bottoming, control and traction are lost.
? With excessive rear end squat, when accelerating out of corners, the bike will tend to steer wide.
Solution: Insufficient compression. Increase compression "gradually until traction and control is optimized and/or excessive rear end squat is gone.
Shock: Too Much Compression
Symptoms:
? Ride is harsh, but not as bad as too much rebound. As speed increases, so does harshness.
? There is very little rear end squat. This will cause loss of traction/sliding. Tire will overheat.
? Rear end will want to kick when going over medium to large bumps.
Solution: Decrease compression until harshness is gone. Decrease compression until sliding stops and traction is regained.
Mark Thompson has spent the past 20 years racing motorcycles and managing Race teams and riders. He now runs the Trackbikes Website along with a number on Internet Ventures
Trouble Shooting Suspension Problems.Adjustment locations: ForksRebound adjustment (if applicable) is located near the top of the fork. Compression adjustment (if applicable) is located near the bottom of the fork. Spring preload adjustment (if... Read More
William Harley and Arthur Davidson, both in their early twenties, built their first motorcycle in 1903. During their first year, the company's entire output was only 1 motorbike; however, by 1910, the company... Read More
With the depreciation on motorcycles being so enormous after they are driven off the showroom floor, the potential for a buyer owing more on their motorcycle loan than the bike is worth it... Read More
Motorcycles are becoming more popular because of its convenience and relatively inexpensive cost compared to automobiles. They are capable of the same speeds as cars and can also be licensed for use on... Read More
A beautiful ride across cities and places named World Heritage by the Unesco, through an splendid protected natural area and ending in a surrealistic garden by artist Sir Edward James. Just keep reading...... Read More
Suspension Set-up: The basicsWhether you are a road rider or a racer correct suspension setup is the key to fast smooth riding and consistent lap times. To get the best out of your... Read More
?And everyone is a racer. If you doubt that, you've obviously never driven in New York City during rush hour. Look closely at the driver of that Japanese luxury car. He's just as... Read More
So you want to be a custom bike builder? Well friend, before you rush out and buy that motorcycle kit, the one that will set you on the road to riches and fame,... Read More
To really understand the women and her ride, one needs to go back in history to explore the courageous women who defied the norm and road their horses in the freedom of the... Read More
Whether interest rates are high or low or it's the end of a model year with lots of incentives, motorcycle buyers tend to make the same mistakes when shopping for a motorcycle loan.... Read More
Need a Harley Davidson Part for your ride?Where do you get a good quality Harley Davidson Part? Can I use an aftermarket part?These questions are not easy to answer. It depends a lot... Read More
Vintage Car & Motorcycle restoration enthusiasts all share one thing in common...The difficulty in obtaining obsolete spare parts.How many times have you tried to find a special part for your restoration project, only... Read More
"With oil prices spiraling higher almost every day, people are starting to look for alternative modes of transport," says Michael S. Milstead of Scootertronics. "With scooters, commuters can slash their gas bills and... Read More
There is some great looking motorcycle clothing on the market these days, but believe me not all of the motorcycle clothing offers as much protection as you think. In Europe, for motorcycle clothing... Read More
A very clever design: the Honda Super Cub was the combination of a moped and a scooter. It attracted many people due to its friendly and non intimidating look. People who before had... Read More
Mini Motos have been around in the UK for around ten years now. The first bikes we're cobbled together with parts that were already available. Small 2 stroke engines, mainly from garden machinery,... Read More
We have heard a whole lot of talk about fuel cells and of course it is a worthy endeavor. Portable generators, cars, transportation industry, Power generators, Ships, etc. can benefit. However in a... Read More
Everyone has wanted to sell a car at some point and in the age of Internet auctions, there are more options than ever when it comes to selling your car whether it's an... Read More
As the latest craze of Minimoto Madness continues in the United Kingdom. The demand for pocket bikes means that the consumer is now looking for more better quality products which are not only... Read More
All rubber tires wear down over time, whether they're on a motorcycle or automobile. However, you want to watch out for uneven or excessive wear, both of which can cause serious problems for... Read More
Motorcycle accident is an unexpected occurrence that results to shock and trauma, serious physical injuries and death. The most common reason of a motorcycle accident, which contributed to the 50% of the motorcycle... Read More
Speeding is illegal, yet we sell racing motorcycles and cars which are so powerful and look so intimidating that a police man could write the owner a ticket even if it were parked.... Read More
For every motorcycle enthusiast, it is indeed very taxing to maintain bikes as good as new ? its engine running and all its other parts functioning. We know for a fact that it's... Read More
Roaring up on a motorcycle has a strong draw for all of us who have adopted the biker lifestyle. This draw often hits our children too. I know that for me my kids... Read More
Many motorcyclists want to take their bikes onto the track and trackdays are the ideal environment. If you have never been on a track before the experience can feel daunting so here are... Read More
Call them crash protectors, crash bobbins, fairing protectors or frame sliders, all these products ultimately seek to do one thing - protect your expensive bodywork or the essential and often expensive structural parts... Read More
When shopping for a certain item and material, the way to do it is to shop like a woman. Who else knows how to shop till they drop but women, right? Isn't it... Read More
This is always a difficult one to answer when shopping for motorcycle parts and I firmly believe that each one of us must decide what's best for our bikes AFTER carefully evaluating each... Read More
These are some quick adjustments and tips for the B1 liquid cooled minimoto that I have found helpful.Extra heat protection:To protect the bike I've put some aluminium tape on the inside of the... Read More
Personal scooters are a highly valuable mobility tool for those who, for health reasons, are unable to move around in public or in their own homes. They can ease the burden of having... Read More
When shopping for a certain item and material, the way to do it is to shop like a woman. Who else knows how to shop till they drop but women, right? Isn't it... Read More
Need a Harley Davidson Part for your ride?Where do you get a good quality Harley Davidson Part? Can I use an aftermarket part?These questions are not easy to answer. It depends a lot... Read More
Everyone has wanted to sell a car at some point and in the age of Internet auctions, there are more options than ever when it comes to selling your car whether it's an... Read More
For every motorcycle enthusiast, it is indeed very taxing to maintain bikes as good as new ? its engine running and all its other parts functioning. We know for a fact that it's... Read More
Motorcycle accident is an unexpected occurrence that results to shock and trauma, serious physical injuries and death. The most common reason of a motorcycle accident, which contributed to the 50% of the motorcycle... Read More
We have heard a whole lot of talk about fuel cells and of course it is a worthy endeavor. Portable generators, cars, transportation industry, Power generators, Ships, etc. can benefit. However in a... Read More
Whether interest rates are high or low or it's the end of a model year with lots of incentives, motorcycle buyers tend to make the same mistakes when shopping for a motorcycle loan.... Read More
Pocket bikes are miniature motorcycles -- powered, for the most part, by oil- and gas-burning engines similar to those used in chain saws, weed whackers or other small motorized tools -- and they... Read More
Mini Motos have been around in the UK for around ten years now. The first bikes we're cobbled together with parts that were already available. Small 2 stroke engines, mainly from garden machinery,... Read More
These are some quick adjustments and tips for the B1 liquid cooled minimoto that I have found helpful.Extra heat protection:To protect the bike I've put some aluminium tape on the inside of the... Read More
There is some great looking motorcycle clothing on the market these days, but believe me not all of the motorcycle clothing offers as much protection as you think. In Europe, for motorcycle clothing... Read More
Standard radar detectors were not built for motorcycles and were never intended to be used on them. Most detectors use an audio device to inform the driver that radar had been detected, and... Read More
To most riders, motorcycle helmets do not fit into their dream accessory. They feel helmets are restrictive and unnecessary and do not add to their aesthetic appeal. But it is important to know... Read More
This summer is showing all of the signs of being a hot one. Temps have already been hitting the 100's here in the Midwest. With that kind of heat we have to remember... Read More
What are Mini moto's? A Minimoto is a miniature version of a real GP racing motorcycle; it just doesn't go as fast as one. There pocket bikes are available in many different makes... Read More
William Harley and Arthur Davidson, both in their early twenties, built their first motorcycle in 1903. During their first year, the company's entire output was only 1 motorbike; however, by 1910, the company... Read More
Trouble Shooting Suspension Problems.Adjustment locations: ForksRebound adjustment (if applicable) is located near the top of the fork. Compression adjustment (if applicable) is located near the bottom of the fork. Spring preload adjustment (if... Read More
One of the most important parts of any vehicle is its tires. Not only are the tires subject to a large amount of wear and tear, but also their durability depends largely upon... Read More
Started in a small warehouse by Michio Suzuki back in 1909, Suzuki aimed at making better looms for the Japanese silk industry. It was only thirty years after its existence that the company... Read More
All rubber tires wear down over time, whether they're on a motorcycle or automobile. However, you want to watch out for uneven or excessive wear, both of which can cause serious problems for... Read More
Vintage Car & Motorcycle restoration enthusiasts all share one thing in common...The difficulty in obtaining obsolete spare parts.How many times have you tried to find a special part for your restoration project, only... Read More
?And everyone is a racer. If you doubt that, you've obviously never driven in New York City during rush hour. Look closely at the driver of that Japanese luxury car. He's just as... Read More
Many mini moto modifications will require you to remove the engine from the mini moto. This is why I have produced the following guide.Firstly you will need to remove the mini moto's fairing.Start... Read More
If you are one of the many people who consider your bike as invaluable as your family, then we know you're head over heels. We may be judged heavily for this perception but... Read More
With the depreciation on motorcycles being so enormous after they are driven off the showroom floor, the potential for a buyer owing more on their motorcycle loan than the bike is worth it... Read More
It is common knowledge that motorcycle lenders base high importance on your FICO credit scores when approving motorcycle loans. However, what many people overlook is that their FICO credit score can highly impact... Read More
As the latest craze of Minimoto Madness continues in the United Kingdom. The demand for pocket bikes means that the consumer is now looking for more better quality products which are not only... Read More
Call them crash protectors, crash bobbins, fairing protectors or frame sliders, all these products ultimately seek to do one thing - protect your expensive bodywork or the essential and often expensive structural parts... Read More
| GOOGLE AD |
Motorcycle Motorcycle |